Soal - soal ini berdasarkan dari soal MTCRE
Soal - soal ini dimaksudkan untuk latihan dan untuk dipelajari. Jawaban dari soal-soal ini belum tentu semuanya benar, apabila ada jawaban yang keliru, mohon diberitahu pada kolom komentar
Selamat mengerjakan, semoga lulus ujian dan semoga tetap istiqomah semangat belajarnya :)
1. There are 6 routers running OSPF
and connected with each other using point-to-point network types. How many
Designated Routers are there among them?
0/4
A. 1
B. 15
C. 0
D. 6
2. The 'check-gateway' option is
enabled for one route. Select all statements that are true:
0/4
A. In case of failure of the gateway, routes pointing to that
gateway will become inactive
B. Check gateway option can be
configured for Ping, ARP and RARP (reverse ARP)
C. Gateway is checked every 10
seconds and after a single failure, the gateway is considered unreacheable
D. Gateway is checked every 10 seconds and after 2
failures, the gateway is considered unreacheable
4/4
A. the required route is not in the routing
table
B. 5.6.6.6
C. both - half of the traffic will
be routed through one gateway, half through the other
D. 5.5.5.5
4. It is possible to create a
configuration where VLAN and PPTP interfaces are bridged together.
4/4
1. True
2. False
5. Routing protocols used within the
same AS are referred to as Exterior Gateway Protocols.
0/4
1. True
2. False
6. When sending out an ARP request,
an IP host is expecting what kind of address for an answer?
4/4
A. 802.11g
B. IP address
C. VLAN ID
D. MAC Address
7. It is possible to filter ospf
routes within a single ospf area
0/4
True
False
Jawaban yang benar
True
8. A MikroTik system administrator
implemented OSPF Routing protocol in the network. But realized that he has a
static route on the routers. What can be done to make the static route work as
a failover whenever the dynamic routing protocol fails.
0/4
A. He should manually disable the
static routes and enable them whenever OSPF fails
B. He should increase the administrative distance of
the static route
C. Delete all static routes because
there is no way for it to work with OSPF
D. He should use
"netwatch" to trigger static routes whenever OSPF fails
Jawaban yang benar
B. He should increase the
administrative distance of the static route
9. RouterOS main routing table
contains static, RIP, and OSPF routes destined to the same network. Which of
the following routes will be used if the administrative distance of each of the
routing protocol entries is set to their default values?
0/4
A. All three will load balance
B. The RIP route
C. The OSPF route
D. The static route
10. To assign specific traffic to a
route - traffic must be identified by a routing mark. Each packet can only have
one routing mark.
0/4
1. True
2. False
11. Consider the following diagram.
Assuming that all the necessary configuration has already been done on R2
(proxy-arp is disabled), to communicate from a device on LAN1 to a device on
LAN2, which of the following configurations on R1 would enable this?
0/4
A. /ip route add dst-address=0.0.0.0/0 gateway=Ether1
B. /ip route add dst-address=192.168.1.0/24 src-address=192.168.0.0/24gateway=192.168.99.2
C. /ip route add dst-address=192.168.1.0/24 gateway=192.168.99.2
D. /ip route add dst-address=192.168.0.0/24 gateway=192.168.0.1
E. /ip route add dst-address=0.0.0.0/0 gateway=192.168.99.2
0/4
A. Route via gateway 1.1.1.1
B. Route via gateway 3.3.3.3
C. Route via gateway 2.2.2.2
0/4
A. 172.16.0.2
B. 172.16.0.4
C. 172.16.0.1
D. 172.16.0.3
14. PPPoE server only works within
one Ethernet broadcast domain that it is connected to. If there is a router
between server and end-user host, it will not be able to create PPPoE tunnel to
that PPPoE server.
4/4
1. True
2. False
15. Which type of ip route is the
highest priority for routing decision ?
0/4
A. BGP Route
B. Static Route
C. Connected Route
D. OSPF Route
16. Which routing table is used to
apply recursive routing at MikroTik RouterOS
0/4
A. It is only possible on the x86
platform
B. It is not possible
C. It is only possible in the main
routing table
D. It is possible in all the routing tables
installed in a router
17. In case it is not
administratively defined, how is OSPF Router ID determined?
0/4
A. The highest IP address of any
interface included in OSPF
B. Random IP addresses from any
interface included in OSPF
C. Random number
D. The lowest IP address of any active interface
on the router
E. The highest IP address of any
active interface on the router
F. The lowest IP address of any
interface included in OSPF
G. Random IP address from any
interface on the router
0/4
A. will have one vlan tag added to
ethernet header - "102"
B. will have one vlan tag added to ethernet
header - "101"
C. will not go through at all
because vlan1 will drop it
D. will have two vlan tags added to ethernet
header - "101" and "102"
E. Wrong configuration because it is
not possible to have a vlan over another vlan
19. When creating a route, it is
possible to specify the gateway to a network even if the gateway is not
directly connected by using recursive next-hop resolving from an existing
route.
0/4
1. True
2. False
20. When using routing option
'check-gateway=ping' what is the ICMP echo request interval (in seconds)?
4/4
A. 20s
B. 10s
C. 30s
D. 60s
4/4
A. 192.168.0.1
B. 192.168.0.3
C. 192.168.0.4
D. 192.168.0.2
22. For a user (one entry) in local
PPP Secrets/PPP Profiles database, it is possible to:
0/4
A. Allow login by PPPoE and PPTP,
but deny login by L2TP
B. Deny services (like telnet) only
for this user or for one group of users
C. Set max values for transferred data (Rx/Tx)
D. Allow only PPPoE login
E. Allow/deny use of more than one login by this user
23. To securely bridge together 2
remote networks following methods need to be used:
0/4
A. EoIP over PPTP/L2TP with IPsec secret specified
B. IPIP with IPsec secret specified
C. PPTP/L2TP BCP with IPsec secret specified
D. EoIP with IPsec secret specified
E. PPTP/L2TP with IPsec secret
specified
24. RouterOS device has acquired an
IP address from an ISP using DHCP client. The same router is used for assigning
IP addresses to local users using DHCP server, masquerade rule is configured
properly. Packets that are coming from the ISP have TTL=1. Select correct
statement:
0/4
A. Router has access to the Internet, but clients
do not
B. All clients and router have
access to the Internet
C. Router does not have access to
the Internet, but clients have
D. Neither router nor clients have
access to the Internet
0/4
A. 10.1.1.2
B. 25.1.1.1
C. 10.1.5.126
D. 10.1.1.1
0 Comments